LSD R11 Remonte Only – LED Dimmer 12V 5V 24V 36V 8A PWM Wireless RF Switch with 2.4G brightness adjustment touch Remote for Led Single Color strip *****

LED Dimmer 12V 5V 24V 36V 8A PWM Wireless RF Switch with 2.4G brightness adjustment touch  Remote for Led Single Color strip

Features:

• Remote control or connected with external push switch to achieve on/off and dimming function
• Ultra sensitive brightness adjustment touch slide
• Smooth dimming and switch without any flickering
• Auto-transmitting function: Controller automaticly transmit signal to another controller with 30m control distance
• Synchronize on multiple number of controllers
• Magnet on the back which can be easily stuck on back holder or any metal surfaces

Technical Parameters:
LED Receiver(LSD-V1)
Input voltage:DC5V 12V 24V 36V
Input current:8.5A
Output voltage:DC5V 12V 24V 36V
Output current:1CH,8A
Output power:40W(5V)/96W(12V)/192W(24V)/288W(36V)
Dimming level:4096 levels
Dimming range:0 -100%
Dimming curve:Logarithmic
PWM Frequency:500Hz
LED Remote(LSD-R11)
Output signal:RF(2.4GHz)
Working voltage:3VDC(CR2032,Without battery)
Working current:＜5mA
Standby current:＜10μA
Remote distance:30M
Match Guide:

The dimmer can match with all kinds of single or multiple zone 2.4G RF dimming remote controller.

Choice 1: Use Match key

1. Match: Short press match key, within 5s, press on/off key of the remote.
2. Delete: Long press match key for 5s, delete all matched remote.

Choice 2: Use Power-up

1. Match: Switch off the power, then switch on power again,short press on/off key 3 times on the remote quickly within 5s after power on, the link is done once the light blinks 3 times.
2. Delete: Switch off the power, then switch on power again,short press on/off key or zone key 5 times on the remote quickly within 5s after power on,the unlink is done once the light blinks 5 times.

Push Dim Function
The provided Push-Dim interface allows for a simple dimming method using commercially available non-latching
(momentary) wall switchs.

• Short press:

Turn on or off light.

• Long press (1-6s):

Press and hold to step-less dimming,

With every other long press, the light level goes to the opposite direction.

• Dimming memory:

Light returns to the previous dimming level when switched off and on again, even at power failure.

• Synchronization:

If more than one controller are connected to the same push switch, do a long press for more than 10s,
then the system is synchronized and all lights in the group dim up to 100%.
This means there is no need for any additional synchrony wire in larger installations.
We recommend the number of controllers connected to a push switch does not exceed 25 pieces,
The maximum length of the wires from push to controller should be no more than 20 meters.